Results 1 to 2 of 2

Thread: New Version of Chanalyzer 4 (4.2.1.28) doesn't show all APs when older version did.

  1. #1

    Default New Version of Chanalyzer 4 (4.2.1.28) doesn't show all APs when older version did.

    Upgraded to the newest version of Chanalyzer 4 (4.2.1.28) not too long ago and noticed that some access points that would show up on older versions (4.1.5.1121) no longer show up on this newest version. I'm specifically talking about the "parabolas" in the density veiw.
    You can see on ch11 there is something there transmitting a signal, but doesn't show the parabola. Those APs on ch11 never turned off. Oddly enough, if I kill my AP on ch1, then the APs on ch11 suddenly appear. Shortly after my AP reboots, the APs on ch11 no longer appear.
    Any thoughts?

    Video showing issue here: http://www.youtube.com/watch?v=W7WjTEGHUYk

  2. #2

    Default

    That's pretty strange! Do you see the same behavior with inSSIDer? And you say you've reverted to the older version of Chanalyzer, and you aren't having the same problem with it?
    Joel, Mobility+, ECSE, CWNE #233
    Technical Trainer
    MetaGeek

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •