Upgraded to the newest version of Chanalyzer 4 (4.2.1.28) not too long ago and noticed that some access points that would show up on older versions (4.1.5.1121) no longer show up on this newest version. I'm specifically talking about the "parabolas" in the density veiw.
You can see on ch11 there is something there transmitting a signal, but doesn't show the parabola. Those APs on ch11 never turned off. Oddly enough, if I kill my AP on ch1, then the APs on ch11 suddenly appear. Shortly after my AP reboots, the APs on ch11 no longer appear.
Any thoughts?
Video showing issue here: http://www.youtube.com/watch?v=W7WjTEGHUYk
Bookmarks